Back when I was even less experienced in self-hosting I setup my media/backup server using a RAIDZ1 array and 3 x 8TB disks. It’s been running well for a while and I haven’t had any problems and no disk errors.
But today I read a post about ‘pool design rules’ stating that RAIDZ1 configurations should not have drives over 1TB because the chances of errors occurring during re-silvering are high. I wish I had known this sooner.
What can I do about this? I send ZFS snapshots to 2 single large (18TB) hardrives for cold backups, so I have the capacity to do a migration to a new pool layout. But which layout? The same article I referenced above says to not use RAIDZ2 or RAIDZ3 with any less than 6 drives…I don’t want to buy 3 more drives. Do I buy an additional 8TB drive (for a total of 4 x 8TB) and stripe across two sets of mirrors? Does that make any sense?
Thank you!
You must log in or register to comment.
Acronyms, initialisms, abbreviations, contractions, and other phrases which expand to something larger, that I’ve seen in this thread:
Fewer Letters More Letters RAID Redundant Array of Independent Disks for mass storage SATA Serial AT Attachment interface for mass storage ZFS Solaris/Linux filesystem focusing on data integrity
3 acronyms in this thread; the most compressed thread commented on today has 30 acronyms.
[Thread #630 for this sub, first seen 26th Mar 2024, 18:55] [FAQ] [Full list] [Contact] [Source code]