Hello everyone.
I’m getting a hard time with Qualcomm Atheros AR8151 onboard LAN with Debian. It usually drops to 100Mb/s and freezes the network altogether
Settings for enp1s0: Supported ports: [ TP ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full 1000baseT/Full Supported pause frame use: No Supports auto-negotiation: Yes Supported FEC modes: Not reported Advertised link modes: Not reported Advertised pause frame use: No Advertised auto-negotiation: Yes Advertised FEC modes: Not reported Speed: 100Mb/s Duplex: Full Auto-negotiation: on Port: Twisted Pair PHYAD: 0 Transceiver: internal MDI-X: Unknown Supports Wake-on: pg Wake-on: d Current message level: 0x0000003f (63) drv probe link timer ifdown ifup Link detected: yes [ 3.004591] atl1c 0000:01:00.0 enp1s0: renamed from eth0
[ 37.754972] atl1c 0000:01:00.0: atl1c: enp1s0 NIC Link is Up<100 Mbps Full Duplex></br> [ 45.071291] atl1c 0000:01:00.0: atl1c: enp1s0 NIC Link is Up<100 Mbps Full Duplex> [ 45.799689] atl1c 0000:01:00.0: atl1c: enp1s0 NIC Link is Up<100 Mbps Full Duplex>
any tips of what can be done around here? I’m using kernel 6.12.111+deb13-amd64
You must log in or # to comment.
If it’s on a card, ditch it and replace it with a better one. If not, and you’ve got a spare slot, buy a new card.
Removed by mod
Removed by mod
Dumb question, but have you ruled out the cable being bad or corrosion in the socket? Dropping to 100 is usually something bad with the cable.
no tdumb at all. I tried other cables, but I never got a fully cleanup on the socket itself. As it was an auction purchase, I guess some drops of deoxit and a good scrub won’t make things any worse. Thanks!
Removed by mod
Removed by mod
Removed by mod
Does it persist if you change the cable, the device on the far side, the OS? What’s in the log when it drops?
What are you plugged into?
I admit that at this very moment its running on a generic switch. I tried other cables, but no change.
That may be your problem. Do you have multiple 10G cards? Try doing a direct link between two machines. Auto MDIX will take care of the electrical connection but you will need to set static IPs in order to run a iperf3 test
Additionally, make sure you are using cat6/6a cables
deleted by creator
Removed by mod
Removed by mod
