My Jellyfin config has some YAML like this.

# Sometimes work  
devices:  
- /dev/dri/renderD128:/dev/dri/renderD128  
- /dev/dri/card0:/dev/dri/card0

Occasionally when I reboot my server, I end up with no card0 and instead I have /dev/dri/card1. This breaks my Jellyfin server…

I noticed there is also dri/by-path, which I’m guessing is a more stable path than a card index… however, doing this doesn’t work for me.

# No work  
devices:  
- /dev/dri/by-path/pci-0000:00:02.0-render:/dev/dri/renderD128  
- /dev/dri/by-path/pci-0000:00:02.0-card:/dev/dri/card0

I tried with and without quotes and the result is the same. Error to start. I’m guessing Docker is failing to correctly parse the string because of the colons in pci-0000:00:02.0-card…

How’s everyone else handling this problem? I’ve been updating my compose.yaml every time the index switches, card0 to card1 to card0… but this is getting annoying now. (This is a worse problem now that I’m running Fedora IoT!)

Any thoughts?

  • miaowoo_lw@lemmy.worldEnglish
    1·
    3 hours ago

    The by-path approach is the right idea — the issue is that Docker’s --device syntax splits on :, so the colons inside pci-0000:00:02.0-card confuse the parser (container_path gets mangled). Two things to try:

    1. Re-check the exact by-path filenames. They must match what’s actually in /dev/dri/by-path/ on your host — e.g. on Intel iGPU it’s usually pci-0000:00:02.0-card and pci-0000:00:02.0-render, but on some boards the PCI address differs. Run ls -l /dev/dri/by-path/ and confirm the symlink targets exist.

    2. Drop card entirely — you likely only need the render node. Modern VAAPI/QSV transcoding in Jellyfin works fine with just the render device, no card0 needed:

    devices:
  - /dev/dri/by-path/pci-0000:00:02.0-render:/dev/dri/renderD128

    This is also the most robust fix for your reboot problem: the render node via by-path doesn’t shuffle between reboots, so your compose file stops breaking.

    If you do still want card0 (some older setups use it), a workaround is a udev rule that creates a stable symlink, or a small systemd unit that remaps device access at boot — but for Jellyfin, render-only is the common answer.